BMW M3 SEDAN Owner's Manual page 102

CONTROLS
Malfunction
In the event of an electrical malfunction, operate
the unlocked trunk lid manually with a slow and
smooth motion.
Trunk emergency unlocking
Pull the handle inside the cargo area.
The trunk lid unlocks.
Valet parking mode
Concept
In the valet parking mode, the Control Display is
locked. The operation via iDrive is no longer pos‐
sible.
E.g., this mode can be used when the vehicle is
handed over for valet parking.
General information
In the valet parking mode, it is not possible to
change vehicle settings via iDrive. Personal pro‐
files cannot be changed. Personal data cannot
be displayed.
Additionally, the following actions are carried out:
▷ The volume of the audio system is limited.
▷ The integrated remote control is deactivated.
▷ DSC cannot be switched off.
▷ Depending on the vehicle, the trunk lid can
be locked and disconnected from the central
locking system.
102
Opening and closing
Online Edition for Part no. 01405A1E4B0 - X/20
Functional requirements
▷ At least one driver profile has been created.
▷ A driver profile or the guest profile is active.
▷ At least one driver profile has an assigned
ConnectedDrive account.
Accessing the menu for the valet
parking mode
Via the switch-off screen
After switching off drive-ready state the switch-
off screen will be displayed. Select the entry for
the valet parking mode on the switch-off screen.
Via the display bar at the upper edge
of the Control Display
1. Tip the Controller up.
2. "Valet parking mode"
Via the vehicle settings
1. "CAR"
2. "Settings"
3. "General settings"
4. "Valet parking mode"
Activating the valet parking
mode
General information
Before activating the valet parking mode, a PIN
must be set up to be able to deactivate the valet
parking mode at a future time.
The procedure for entering the PIN varies de‐
pending on the active driver profile.
Driver profile with PIN
A PIN has been stored for the active driver pro‐
file.
It is not necessary to enter another PIN.
1. Depending on the vehicle, select the desired
setting, if necessary: