BMW M3 SEDAN Owner's Manual page 265

Yellow lines in the screen display mark the front
and rear end of the vehicle.
The camera image shows different levels of dis‐
tortion in some areas and is thus not suitable for
distance estimations.
Depending on the equipment version, the func‐
tion can only be used when driving forward.
Additional information:
Surround View, refer to page 259.
Safety information
Warning
The system cannot serve as a substitute for the
driver's personal judgment in assessing the
traffic conditions. There is a risk of accident.
Adjust driving style to traffic conditions. Watch
traffic and vehicle surroundings closely and ac‐
tively intervene where appropriate.
Overview
Button in the vehicle
Panorama View
Sensors
The system is controlled by the following sen‐
sors:
▷ Front camera.
▷ Depending on the equipment: rearview cam‐
era.
Driver assistance systems
Online Edition for Part no. 01405A1E4B0 - X/20
Additional information:
Sensors of the vehicle, refer to page 35.
Display on the Control Display
Press the button when the engine is run‐
ning.
Depending on the driving direction, the image of
the respective camera is displayed:
▷ "Front": front camera image.
▷ "Rear": rear camera image.
Depending on the vehicle equipment, cross traf‐
fic warning can additionally warn of approaching
vehicles using radar sensors.
Additional information:
Cross traffic warning, refer to page 267.
With navigation system:
activation points
Concept
Positions where Panorama View should switch
on automatically can be stored as activation
points provided that a GPS signal is received.
General information
Up to ten activation points can be stored.
Activation points can be used when driving for‐
ward for the front camera.
Storing activation points
1. Drive to the position at which the system is to
be switched on, and stop.
2. Press the button.
3. Move the Controller to the right.
4. "Activation point"
The current position is displayed.
5. "Save activation point"
CONTROLS
265