Advanced Functions - Siemens SENTRON 7KT PAC1600 Equipment Manual

3.5.2

Advanced functions

Procedure
1. Press both the "Increase" and "Decrease" keys simultaneously from any display.
The device changes to the Menu display.
2. Press "Increase" or "Decrease" key to change to the Set display.
3. Confirm your selection by pressing the "Next" key.
Enter password appears on the display.
4. Confirm your selection by pressing the "Next" key.
5. Enter the password.
Press "Increase" or "Decrease" to change the flashing digit.
Confirm your digit selection by pressing the "Next" key.
– If the password is incorrect, PASS Er appears on the display.
– If the password is correct, Advanced password ok appears on the display.
6. The first entry in the following list appears on the display:
– CLEAR P: Clear partial energy meters
– CLEAR h: Clear partial hour counter (if activated)
– CLEAR d: Clear maximum demand values (if activated)
– ET-DEF: Set all parameters to the default values.
– SETUP: Parameter programming (setup)
– INFO: Revision and checksum of internal software
– ESC: Return to normal mode
Press the "Increase" or "Decrease" key to scroll through the list.
7. Press the "Next" key to select a function.
Note
If you do not press the keys for more than 120 s, the menu closes automatically.
7KT16 energy meter
Equipment Manual, 09/2020, 2514284147-04
Press the "Next" key.
Enter the password again.
Press the "Next" key.
Description
3.5 Three-phase devices 5 A
45