Selection Of Measured Values - Siemens SENTRON 7KT PAC1600 Equipment Manual

Description
3.5 Three-phase devices 5 A
3.5.3

Selection of measured values

Use the "Decrease" and "Next" keys to scroll through the display pages of the measured
variables in succession.
Some measurements may not be displayed on the device depending on parameterization and
the connection.
Example:
If you have programmed for a system without a neutral conductor, the measurements for the
neutral conductor cannot be displayed.
The "Next" key gives you access to subpages (e.g. to display the highest and lowest values
recorded for the selected measurement).
The currently displayed page is indicated on the bottom right by one of the following
symbols:
• IN = Instantaneous value
Current instantaneous value of measurement, which is displayed as a default on every
change of page.
• HI = Highest peak
Highest value measured by the energy meter for the selected measurement. Peak values
are also stored and retained when the power supply is switched off. A special command
exists for resetting the stored peak values. You can find more information on this in
chapter Command menu (Page 64).
• LO = Lowest value
Measured by the energy meter from the time when voltage was present. You can reset
this value with the same command that is used for HI values. You can find more
information on this in chapter Command menu (Page 64).
• AV = Average value
Time-integrated (average) value of measurement. You will find more information on
parameter "P04 Integration" in chapter Parameter table (Page 54).
• MD = Max. demand value
This is not stored in volatile memory and can be reset using a special command.
46
7KT16 energy meter
Equipment Manual, 09/2020, 2514284147-04