Command Menu - Siemens SENTRON 7KT PAC1600 Equipment Manual

Description
3.5 Three-phase devices 5 A
3.5.4.8

Command menu

The command menu allows you to perform occasional operations (e.g. to reset measured
variables and counters).
After entering the password for the extended level, you can also use the command menu to
perform a number of automatic operations which are useful for the configuration of the
device.
The following table shows the functions that are available in the command menu, separated
according to the required access level.
Note
C.11 cannot be selected with MID devices.
Code
C.01
C.02
C.03
C.04
C.06
C.07
C.08
C.11
C.12
C.13
C.14
C.15
C.16
1. Select the required command.
2. Press the "Next" key to execute the command.
3. Press the "Next" key again to execute the command.
4. Press MENU to cancel command execution.
5. Simultaneously press the "Increase" and "Decrease" keys to exit the command menu.
64
Command
RESET HI-LO
RESET MAX DEMAND
RESET PAR.ENERGY
RESET PAR.HOURS
RESET TARIFFS
RESET ALARMS
RESET LIMITS
RESET TOT.ENERGY
RESET TOT.HOURS
SETUP TO DEFAULT
BACKUP SETUP
RESTORE SETUP
WIRING TEST
Access level Description
User level/ Resets the HI and LO values of all
measurements.
Administrator
Resets the maximum demand values
for all measurements.
Resets the partial energy meters.
Resets the partial hour counters.
Resets the energy meters for tariffs 1
and 2.
Resets alarms.
Resets limit values.
Administrator Resets the total and partial energy
meters.
Resets the total hour counter.
Restores all the factory settings for the
device.
Saves a backup copy of all setup pa-
rameters.
Loads the settings from the backup
copy.
Runs the test to check whether the
device is connected correctly. See chap-
ter Wiring test (Page 65).
Equipment Manual, 09/2020, 2514284147-04
7KT16 energy meter