Identification Of Functional Module - Grundfos Hydro Multi-E Series Installation And Operating Instructions Manual

7. Connect the cable screens of the bus cables to earth via one
of the earth clamps (fig. 16, A).
Fig. 16 Connecting the cable screens to earth
8. Route the wires for the CIM module. See the example in fig.
17.
Fig. 17 Example of wire routing
9. Fit the CIM cover.
10. If the CIM module is supplied with an FCC label, then place
the label on the terminal box. See fig. 18.
Fig. 18 FCC label
11. Fit the terminal box cover (fig. 12, B) and cross-tighten the
four mounting screws (fig. 12, A) to 6 Nm.
Make sure that the terminal box cover is aligned with
the control panel.
A
FCC

8. Identification of functional module

You can identify the fitted module in one of the following ways:
Grundfos GO Remote
You can identify the functional module in the "Fitted modules"
menu under "Status".
Pump display
For pumps fitted with the HMI300, you can identify the functional
module in the "Module type" menu under "Status".
Motor nameplate
You can identify the fitted module on the motor nameplate. See
fig. 19.
Typ Type : ype : P.C. : P.C. : INPUT INPUT
P.N. : P.N. : Serial no : Serial no : U U in in : :
~ ~
DE : DE : Env.Ty y pe Env.Type : p : TEFC TEFC V V n n max:
NDE : NDE : SF SF : : CL: CL: f f in in : : Hz Hz Eff Eff
Wg g t : Wgt : kg kg g T T : : F F PF: PF: I I : : A A I I : : A A
amb amb SF Amp p SF Amp 1/1 1/1
Fig. 19 Identification of functional module
Variant Description
FM 200 Standard functional module
FM 300 Advanced functional module
VARIANT
Hp Hp PB PB :
:
OUTPUT VARIANT
P2 P : rpm rpm Hp PB :
FM :
rpm FM :
: HMI : Made in Hungary
HMI HMI: :
CIM :
DK - 8850 Bjerringbro, Denmark
CIM : :
CIM
11