Factory Settings - Grundfos Hydro Multi-E Series Installation And Operating Instructions Manual

29. Factory settings

● Function is enabled.
❍
Function is disabled.
- Function is not available.
Settings
"Setpoint"
"Operating mode"
"Control mode"
"Pipe filling function"
"Buttons on product"
"Stop function" (Low-flow stop function)
"Controller" (Controller settings):
"Ti"
"Kp"
"Operating range"
Ramps
Ramp-up
Ramp-down
"Number" ("Pump number")
"Radio communication"
"Analog input 1"
"Analog input 2"
"Analog input 3"
"Pt100/1000 input 1"
"Pt100/1000 input 2"
"Digital input 1"
"Digital input 2"
"Digital in/output 3"
"Digital in/output 4"
"Pulse flowmeter"
Predefined setpoints
"Analog output"
"External setpoint function"
"Signal relay 1"
"Signal relay 2"
"Limit 1 exceeded"
"Limit 2 exceeded"
"LiqTec"
Standstill heating
"Motor bearing monitoring"
"Pump name"
1)
Only available if an advanced functional module, type FM 300, is fitted.
2)
Active if inlet sensor is fitted from factory.
3)
Not active if inlet sensor is fitted from factory.
CRE
30 % of sensor range
"Normal"
"Constant pressure"
"Not active"
"Active"
"Active"
●
0.5
0.5
25-100 %
1 second
3 seconds
-
"Active"
"4-20 mA"
"Not active"
2)
"Not active"
"Not active"
"Not active"
"External stop"
"Not active"
3)
Dry running
"Not active"
"Not active"
"Not active"
"Not active"
"Not active"
"Ready"
"Running"
"Not active"
"Not active"
"Not active"
"Not active"
"Active"
Hydro Multi-E
43