Installing A Phased Array Probe; Connecting A Probe - GE Phasor CV Operating Manual

AMP COLOR PALET—Select the colors used to
represent ranges of amplitude values when sector
or linear scans are displayed.
VIDEO REVERSE—Reverse the orientation of Dis-
played Sector Scans (left to right) and Linear Scans.
Step 3: Press under BACKGRND Submenu, then
press next to one of the following functions:
COLOR—Select the display's color scheme, which
is applied to the reading boxes.
COLOR LEG—Turn the displayed leg lines ON or
OFF
IMAGE BACKGRND—Sets the background color
displayed around the sector scan.
ASCAN COLOR—Select the A-Scan's color
Step 4: To change the value of the select function,
continue pressing the corresponding
function knob.
Step 5: Press under STARTUP (located in the
CONFIG menu), then press
Press or turn the Function Knob to select settings
from 1 to 10.
Step 6: The selected function will remain at the
value last displayed.
FIGURE 2-2—Phased Array Probe Attachment
PHASOR XS Operating Manual
or turning the
next to BRIGHTNESS.
2. Setting Up for Phased Array Measurement
2.3

Installing a Phased Array Probe

NOTE: Modifying certain settings related to probe or
scan configuration will require a recalculation of the
delay laws. When such a change is made, the modi-
fied function will turn red, indicating that the effect of
this change will not take affect until the new delay-law
calculation is carried out. To command a calculation,
press and hold for three seconds or access the
SCAN PATT Submenu and press
Function.

2.3.1 Connecting a Probe

When connecting a probe to the instrument, it's not only
important that the probe's physical connection be properly
made, but that the instrument is properly configured to
work with the installed probe. To install a phased array
probe, connect it to the front of the instrument. Be sure
to install it with the probe cable facing up and to operate
the probe-release lever as shown in
next to the CALC
Figure 2-2.
Page 17