Connecting The Ecg Cable To The Recorder And To The Electrodes - GE SEER 1000 Operating Manual

Preparing the Recording
Connecting the ECG Cable to the Recorder and to the
Electrodes
Connect the ECG cable to the recorder and to the electrodes.
NOTE
If both LED alternatively flash between green and yellow three times
per second, the recorder is defective and service is needed. Refer to
the section "How to Notify Service if the Recorder is Defective" on
page 91.
NOTICE
CONNECTOR AND RECORDER DAMAGE – The cable can be connected
to the recorder in one orientation only.
For correct orientation, align the marks on connector and recorder as
shown in the left graphic below.
Do not try to connect the cable any other way.
CAUTION
CABLE DAMAGE – Damaged ECG cables are the most frequent causes
of bad or insufficient recordings.
Check the cable before connecting the electrodes.
NOTICE
CONNECTOR AND CABLE DAMAGE – Excessive force can damage
connector and cable.
Never use force to plug the ECG cable into the recorder, and do not
excessively bend the ECG cable or wrap it around the device.
44 SEER™ 1000 2067634-077 Revision B