Table of Contents
Advertisement
Remove the front-wheel
stand.
without centre stand
Remove the auxiliary stand.
Place the motorcycle on its
side stand.
Removing rear wheel
Make sure the ground is level
and firm and place the mo-
torcycle on a suitable auxiliary
stand.
Install the rear-wheel stand
(
192).
with centre stand
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Slip wooden chocks or sim-
ilar under the rear wheel to
prevent it from dropping out
after the quick-release axle
has been removed.
Press the brake caliper 1
against the brake disc 2.
OE
OE
Brake pistons are pushed
back.
Remove screw 3 and remove
the wheel speed sensor from
its bore.
Remove axle nut 4 and
washer 5.
Remove chain tensioner 6 and
push the axle in as far as pos-
sible.
209
Advertisement
Table of Contents
