Table of Contents
Advertisement
if the ignition is subsequently
switched off. The power sock-
ets are switched off approx-
imately 15 minutes after the
ignition is switched off, in order
to prevent overloading of the
on-board electrical system.
Low-wattage electrical
accessories might not be
recognised by the vehicle's
electronics. In such cases,
power sockets are switched off
very shortly after the ignition is
turned off.
Cable routing
Note the following with regard
to the routing of cables from
sockets to items of electrical
equipment:
Make sure that cables do not
impede the rider.
Make sure that cables do not
restrict the steering angle or
obstruct handling.
Make sure that cables cannot
be trapped.
USB CHARGING SOCKET
Notes on use:
Charge current
This is a 5 V USB charging in-
terface that provides a max-
imum charge current of 2.4 A.
Automatic shutdown
The USB charging sockets are
shut down automatically under
the following circumstances:
If battery charge state is too
low, to maintain the motor-
cycle's start capability.
If the maximum load capacity
as stated in the technical data
is exceeded.
During the starting operation.
Connection of electrical
devices
You can start using electrical
devices connected to the USB
charging sockets only when the
ignition is switched on. The
power supply to the sockets
is switched off no more than
15 minutes after the ignition is
switched off, in order to pre-
vent overloading of the on-
board electrics.
While riding in the rain, you
should disconnect the device
from the interface in order to
protect against damage.
To prevent dirtying, keep the
protective cover closed when
no device is connected.
Cable routing
Note the following with regard
to the routing of cables from
USB charging sockets to items
of electronic equipment:
229
Advertisement
Table of Contents
