Table of Contents
Advertisement
40
STATUS INDICATORS
The front tyre pressure is on
the left 1; the reading on the
right 2 is the rear tyre pressure.
" " appears directly after the
ignition is switched on. The
sensors do not start transmit-
ting tyre pressure signals until
the first time the vehicle accel-
erates to more than 30 km⁄h.
The tyre pressure readings are
based on a reference tyre air
temperature of 20 °C.
If the 3 symbol also
shows, this is a warning.
The critical tyre pressure
flashes.
If the value in question is
close to the limit of the
permissible tolerance range,
the reading is accompanied
by the 'General' warning
light showing yellow. If the
tyre pressure registered by
the sensor is outside the
permissible tolerance range,
the 'General' warning light
flashes red.
For more information on the
BMW Motorrad RDC system of
tyre pressure monitoring, see
(
183).
Tyre pressure in limit range of
the permitted tolerance
with tyre pressure control
(RDC)
OE
lights up yellow.
The tyre symbol is dis-
played with one or two
arrows. The critical tyre pres-
sure flashes.
The up arrow indicates a
pressure problem on the
front wheel, the down arrow
indicates a pressure problem
on the rear wheel.
Possible cause:
Measured tyre pressure is close
to the limit of permitted toler-
ance.
Correct the tyre pressure as
stated on the inside cover of
the Rider's Manual.
Before adjusting tyre
pressure, read the
information on temperature
compensation and adjusting
pressure in the section entitled
"Engineering details".
Advertisement
Table of Contents
