Troubleshooting
Pan/Tilt/Roll axes – incorrect axis control or some axes do not work
Check that the Veracity wheels start up in the correct mode for your gimbal (MōVI, Maxima, or Ronin). See section on
"Switching between MōVI (Standard Gimbal), Ronin and Maxima Modes".
Nothing happens – no lights, no sound, no motion
Check wiring and ensure power is available on the Veracity Control Wheels. Make sure that your power cable is the
correct polarity for this system.
Hand Wheels & Radio Controller – do not connect
Go to the Appendices section to set up your radio controller or refer to your RC controller manual for information on
configuring the Trainer port. Check that Channels 2, 3, 4 are assigned properly
Axis Drifting
If one or more axis are drifting the system needs to be calibrated for your gimbal, please see the Zeroing section in this
manual. If drift persists, try rebalancing your gimbal and running an auto-calibration from your gimbal (i.e. for the
Maxima, calibrate the gyros and accelerometers).
Lights When Zeroing – do not switch from red to green
When zeroing the switch must be in the middle position to zero the PAN, TILT or ROLL Wheel properly.
Tilt/Roll – does not work
Make sure that all of your cables are connected to the correct ports, you may have your tilt/roll axis plugged into the
incorrect Axis Connector. Make sure that the light is red or green but not flashing.
FCC Declaration
Class B
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
PLC Electronic Solutions Ltd.
www.plcelectronicsolutions.com
Copyright © 2017
Page 33
Need help?
Do you have a question about the Veracity Control Wheels and is the answer not in the manual?