5. You can chose to turn ON or OFF the PAN / TILT / and ROLL axis motors using the Motors On/Off Button as seen
below. It is recommended to keep the motors OFF until the profile has been fully configured and turned back
ON during the Zeroing/Drift Correction procedure. ***Note: When connected to a PC through USB, motors are
always enabled.
6. Switch to Advanced Mode by Clicking the Standard/Advanced button from the Settings > Mode Menu.
PLC Electronic Solutions Ltd.
www.plcelectronicsolutions.com
Copyright © 2017
Page 21
Need help?
Do you have a question about the Veracity Control Wheels and is the answer not in the manual?