4. Once the drift has been corrected, press and hold the Zero Button until the LEDs stop flashing and are lit solid,
then release. The LEDs will go off. The new offsets will be stored in the Veracity Control Wheels flash memory.
***Note: If the Sensitivity dial reaches the endpoint of its rotational range with its axis still drifting:
1. Press and hold the Zero Button to exit from Zeroing Mode.
2. Re-center the Sensitivity Dial.
3. Press and hold the Zero Button to get back into Zeroing Mode and continue to adjust for drift.
PLC Electronic Solutions Ltd.
www.plcelectronicsolutions.com
Copyright © 2017
Page 27
Need help?
Do you have a question about the Veracity Control Wheels and is the answer not in the manual?