Window Structure - ABB RELION REB500 Operation Manual

1MRK 500 132-UEN B
The program can be run in a read only mode by ticking the Read only check box, that is. the
data can be viewed but not changed.
HMI500 obtains the specific device data from a database in a file, which is stored both in the
PC and the protection system. Database files on the PC have the extension .mdb.
Click OK to continue start-up or Cancel to close the program.
When you click OK, HMI500 tests communication with the protection system and starts in the
on-line mode if communication can be established. Otherwise it starts either in off-line or
simulation mode (see
Some of the dialogs used by the program are standard Windows dialogs, whose language
depends on the language setting of the operating system.
4.3.4

Window structure

The structure and handling of the windows in the operator program is similar to other
Windows applications.
IEC18000289 V1 EN-US
Figure 3:
Table 1
Table 1:
Button
OK
Apply
Restore
Cancel
Scroll (arrow) buttons
Close
Distributed busbar protection REB500
Operation manual
When the HMI500 software establishes communication with a REB500 system
initially user must enter a password.
For details about security management, passwords and security options, see
Cyber security Deployment Guideline .
Section 4.9.5).
The database that was open during the last session opens automatically. If no
database was open before, select Open in the File menu and then the desired
file. An error message is displayed if an attempt is made to open an
incompatible file. An existing file in the protection system can also be opened
using the Upload function in the File menu.
Dialog box buttons
summarizes the meaning of buttons that appear in many dialog boxes:
Meaning of common buttons in dialogs
Description
The new settings are saved in the database on the PC and the dialog
closes.
The new settings are saved in the database on the PC and the dialog
stays open.
The changes that have been made are ignored and the old settings
restored. The dialog stays open.
The new settings are not saved and the dialog closes.
In windows permitting the selection of several bays (or isolators,
circuit-breakers etc.), there are four scroll buttons at the bottom for
scrolling through the bays.
The window or dialog is closed and a warning is displayed, if
changes have been made which have not been saved.
© Copyright 2019 ABB. All rights reserved
Section 4
HMI500
GUID-AC8B4D07-B8FC-4B74-85A2-603E6A6BC7B4 v2
12000072-IEC18000289-1-en.vsdx
13