Outputs - ABB RELION REB500 Operation Manual

1MRK 500 132-UEN B
or 2. As the 61850 model is implemented as defined by the standard, no custom assignments
can be made for the IBB associated with 61850.
Minimum input signal duration
Provision is made for prolonging the input signals in steps of 1 ms (reset delay).
New signal
IEC18000508 V1 EN-US
Figure 29: Configuration/ Binary module/ Inputs/ New signal
The button New signal opens a dialog box with a list for selecting and adding a new signal.
Clicking on the arrow to the right of the Signal type field opens a list of available signals. The
effective list depends on the functions ordered by the user. The list can include as a maximum
the following groups:
• General signals
• Busbar protection (BBP)
• Breaker failure protection (BFP)
• End fault protection (EFP)
• Time-overcurrent protection (OCDT)
• Disturbance recorder (DR)
• CB pole discrepancy protection (PDF)
• Voltage release (UV)
Clicking on the arrow button to the right of the signal name field opens a list of the signals
available according to the filter group and device selected.
Signals that can only be assigned once will disappear from the list as soon as the user has
assigned them.
The new signal can be configured as described in
4.6.3.5

Outputs

The procedures for configuring binary inputs and outputs are almost identical, in particular
creating new signals and deleting existing ones. Therefore only the differences are dealt with
in this section.
Distributed busbar protection REB500
Operation manual
Most of the CU signals only occur once. There is an output signal Trip BB zone
for each section of busbar (bus zone), therefore the respective zone must be
given when selecting this signal.
© Copyright 2019 ABB. All rights reserved
12000112-IEC18000508-1-en.vsdx
Section 4.6.3.
Section 4
HMI500
GUID-871AE2B8-1DC5-4AC8-9A84-36113A6BF744 v1
GUID-32775D3A-66F8-4B63-A071-ABE5C9609C46 v2
GUID-B376FC53-03B1-41B9-972F-75C372D838F1 v1
37