Adding A Cisco Telepresence Presentation Codec With A Auxiliary Control Unit - Cisco TelePresence System 1000 Hardware Options & Upgrade Manual

Chapter 2 Options for the Cisco TelePresence System 1000
Step 21 Attach the end caps to the presentation codec assembly.
Tighten the screws until they are snug but do not overtighten.
Note
Figure 2-13 Right End Cap
Power on the CTS-1000 system.
Step 22
Note You might have to reboot your presentation codec several times before it becomes active. For
information about rebooting the CTS-1000, refer to the
Instructions"
Unit

Adding a Cisco TelePresence Presentation Codec with a Auxiliary Control Unit

To add a presentation codec to an CTS-1000 with an auxiliary control unit, complete the steps in the
"Adding a Standalone Presentation Codec" section on page 2-6
cabling steps:
•
OL-16441-01
chapter of the Cisco TelePresence 1000 Assembly, Use & Care, and Field-Replacement
Guide.
Connect the Primary Codec Document Camera Ethernet connection (orange Ethernet connection on
the primary codec) to one Ethernet port of the auxiliary control unit.
Cisco TelePresence Presentation Codec
9
9
7
10
"Field-Replacement and Upgrade Disassembly
and perform the following additional
Cisco TelePresence System
10
2-17