Cisco TelePresence System 1000 Hardware Options & Upgrade Manual page 95

Chapter 5 Upgrading a Cisco TelePresence System 3000 to a Cisco TelePresence System 3200
Step 11 Assemble the I/O modules for the outside left and outside right molded foam bumpers.
The outside left and outside right molded foam bumpers only have one I/O module each. The inner
molded foam bumpers have two (see
Figure 5-16
The Ethernet cables are of different lengths. Attach the Ethernet cables to the I/O modules as follows:
Note
Use the 12M cable, 37-0965-01, for the I/O modules between sections 6 and 5
•
Use the 3M cable, 37-0887-02, for the I/O modules between sections 5 and 7
•
The flange on the I/O module cover piece is wider on the bottom than on the top.
Note
OL-16441-01
Figure
Foam Bumper Assembly
46
43
50
44
45
Building the Second Row Table Assembly
5-17).
47 48 49
Cisco TelePresence System
5-25