Cisco TelePresence System 1000 Hardware Options & Upgrade Manual page 53

Chapter 3 Options for the Cisco TelePresence System 3000
•
For a list of the external displays that Cisco TelePresence supports, refer to the
Note
TelePresence System, Release
Figure 3-13 Cable Routing for Presentation Codec, Auxiliary Control Unit, Document Camera and External Display
Projector
Serial Video In
Presentation Codec
Primary Codec Signal
Document Camera Signal
Auxiliary Video In
Center Left Right
Microphone
Speaker
OL-16441-01
For a CTS-3000 installation that uses an optional document camera, external display, or HDMI
splitter for multiple video displays, use the following wiring diagram for the presentation codec. If
you have an Auxiliary Control Unit, substitute the signal cabling between the presentation codec
and the primary codec with the alternate cabling for the Auxiliary Control Unit.
Auxiliary Control Unit (Optional)
1
SERIA L PO RTS
Video Out
Left Codec
Auxilliary
Network
1.4.
2 1 2
RES ET 10/ 100 NETWORK PO RTS
Serial 2
External Display
Serial 1
Ethernet 1
Ethernet 2
Document
Camera
HD Video
Document
Splitter
Camera
Video Out
Document
Camera
Signal
Right Codec
Camera
Display
Primary
Auxiliary Video Out
Codec
Document Camera
Signal
Video In
IP Phone
Cisco TelePresence Presentation Codec
Release Notes for Cisco
Video
In
Video
Out
Video
In
Primary Codec
Auxiliary Video In
Cisco TelePresence System
3-15