Cisco TelePresence System 1000 Hardware Options & Upgrade Manual page 74

Replacing the New Primary Codec
Step 4 Remove the codec from the Display structure.
Remove the L brackets from the codec.
Step 5
Remove the cable management bar from the codec. Retain the bar and the screws.
Step 6
Make a note of the MAC address of the new primary codec. The MAC address should be printed on a
Step 7
sticker on the codec. You configure Cisco Unified Communications Manager to use the new MAC
address in the
Step 8 Attach the cable management bar to the new primary codec.
Figure 5-1 Cable Management Bar
5
Cisco TelePresence System
5-4
Chapter 5 Upgrading a Cisco TelePresence System 3000 to a Cisco TelePresence System 3200
"Powering On the System" section on page
3
5-71.
1
OL-16441-01