Cisco TelePresence System 1000 Hardware Options & Upgrade Manual page 31
Hide thumbs
Also See for TelePresence System 1000:
- Hardware installation manual (96 pages) ,
- Manual (20 pages) ,
- Hardware upgrade manual (166 pages)
Table of Contents
Advertisement
Chapter 2
Options for the Cisco TelePresence System 1000
Step 16
Access the codec by removing the front panel from the frame. Complete the following steps:
a.
b.
c.
d.
Figure 2-7
Removing the Front Panel From the Frame
Attach the auxiliary control unit to its bracket using the supplied 5 mm screws.
Step 17
Attach the bracket so that the shortest part of the bracket attaches to the wall; otherwise the unit is too
Note
wide to fit between the display supports.
OL-16441-01
Remove the black speaker grille from the top of the front panel by grasping the sides until the pins
pop out of the holes.
Using a #3 Phillips screwdriver, remove the six screws next to the speaker (three on either side).
Pull the front panel away from the frame.
Disconnect the lighting unit from the PDU.
Cisco TelePresence Presentation Codec
Cisco TelePresence System
2-11
Advertisement
Table of Contents
