Connecting The Cisco Telepresence Touch Controller To Codec C20 - Cisco TelePresence System C20 Administrator's Manual

Cisco TelePresence System Quick Set C20 / C20 Plus and Profiles using C20
Contents Introduction
Connecting the Cisco TelePresence
Touch controller to Codec C20
A C Series codec running software version TC4.1 or later can be
controlled using the Cisco TelePresence Touch controller (instead
of using the remote control).
Connecting and setting up the Touch controller
The Touch controller must be connected to Codec C20 via LAN.
Once the unit is connected to power, the set-up procedure
begins. Follow the instructions on screen.
You have to select which codec to associate the Touch
controller with. This process is called pairing.
NOTE: The codec signals that it is available for pairing only for
30 minutes after it is switched on.
If your codec is not in the list of available codecs displayed
on the Touch controller, you can select a codec manually by
entering its IP address.
If the Touch controller needs software upgrade, new software
will be downloaded from the codec and installed on the unit
automatically as part of the set-up procedure. The Touch
controller restarts after the upgrade.
You can verify that the Touch controller is successfully paired to
your codec by checking that the codec address is displayed in
the top banner.
If you want more details on Touch installation, please read the
Cisco TelePresence Touch for C Series Installation Guide, which
you will find on the Cisco web site.
D14637.06 Profile C20 and Quick Set C20 Administrator Guide TC4.2, July 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
Web interface Advanced settings
67
Password protection Appendices Appendices
Codec address
Administrator guide
Contact us
www.cisco.com