Time And Date Setting - ZyXEL Communications Prestige 314 PLUS User Manual

13.3 Time and Date Setting

There is no Real Time Chip (RTC) in the Prestige, so there is a software mechanism to set the time manually
or get the current time and date from an external server when you turn on your Prestige. Menu 24.10 allows
you to update the time and date settings of your Prestige. The real time is then displayed in the Prestige error
logs and firewall logs. If you do not choose a time service protocol that your timeserver will send when you
turn on the Prestige, then you can enter the time manually but each time the system is booted, the time and
date will be reset to 2000/01/01 00:00:00.
Select menu 24 in the main menu to open Menu 24 - System Maintenance, as shown next.
Then enter 10 to go to Menu 24.10 - System Maintenance - Time and Date Setting to update the time and
date settings of your Prestige as shown in the following screen.
System Maintenance & Information
Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
Menu 24 - System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Upload Firmware
8. Command Interpreter Mode
9. Call Control
10. Time and Date Setting
11. Remote Management Setup
Enter Menu Selection Number:
Figure 13-6 Menu 24 — System Maintenance
13-5