Snmp Traps - ZyXEL Communications Prestige 314 PLUS User Manual

Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
FIELD
Get Community
Set Community
Trusted Host
Trap: Community
Trap: Destination
When you have completed this menu, press [ENTER] at the prompt "Press [ENTER] to confirm or [ESC] to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.
9.4

SNMP Traps

The Prestige will send traps to the SNMP manager when any one of the following events occurs:
TRAP #
0 coldStart (defined in RFC-1215)
1 warmStart (defined in RFC-1215)
2 LinkUp
3 LinkDown
4 authenticationFailure (defined in
RFC-1215)
6 whyReboot (defined in ZYXEL-
MIB)
6a For intentional reboot:
9-4
Table 9-1 SNMP Configuration Menu Fields
Type the Get Community, which is the password for the incoming
Get- and GetNext requests from the management station.
Type the Set community, which is the password for incoming Set
requests from the management station.
If you enter a trusted host, your Prestige will only respond to SNMP
messages from this address. A blank (default) field means your
Prestige will respond to all SNMP messages it receives, regardless
of source.
Type the trap community, which is the password sent with each
trap to the SNMP manager.
Type the IP address of the station to send your SNMP traps to.
Table 9-2 SNMP Traps
TRAP NAME
DESCRIPTION
A trap is sent after booting (power on).
A trap is sent after booting (software reboot).
A trap is sent when the link is established.
A trap is sent when the link is down.
A trap is sent to the manager when receiving any SNMP
get or set requirements with wrong community (password).
A trap is sent with the reason of restart before rebooting
when the system is going to restart (warmstart).
A trap is sent with the message "System reboot by user!" if
reboot is done intentionally, (e.g. download new files, CI
command "sys reboot", etc.).
DESCRIPTION
SNMP Configuration
EXAMPLE
Public
Public
Blank
Public
Blank