Prestige Rear Panel And Connections; Figure 2-2 Prestige Rear Panel Connections; Table 2-2Prestige Rear Panel Connections - ZyXEL Communications Prestige 314 PLUS User Manual

Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
LED FUNCTION
WAN WAN
2.2

Prestige Rear Panel and Connections

The following figure shows the rear panel of your Prestige and the related connections.
CONNECTION
Power 12VDC
Reset
LAN 10/100M
Console
WAN 10/100M
F.G.
2-2
COLOR STATUS
Green Off
On
Flashing

Figure 2-2 Prestige Rear Panel Connections

Table 2-2Prestige Rear Panel Connections

DESCRIPTION AND FUNCTION
This supplies the power to the unit. Connect the supplied power adaptor to the
wall outlet and insert the small plug from the power adaptor to this socket.
This button resets the unit. Refer to section 2.7.1 for details on how to reset the
unit.
These auto-sensing LAN ports are used to connect the Prestige to local
computers or to an external hub. All LAN ports are auto-sensing. This means that
these ports automatically adjust according to the type of cable, eg Straight-
through Ethernet cable or Crossover Ethernet cable.
This port is used for configuration and administration of the Prestige. Connect
your administration computer to this port via an RS-232 cable.
Connect your Cable/DSL modem to this port.
Ground the Prestige by connecting a grounded wire to the Frame Ground (F.G)
terminal.
MEANING
The WAN Link is not ready, or has failed.
The WAN Link is ok.
The 10/100M WAN link is sending/receiving
packets.
Hardware Installation & Initial Setup