Page 1
Antenna and Cable Application Guide for the AT-WA7500 and AT-WL2411 Access Points ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 2
Table of Contents Introduction Regulatory Concerns Basic Antenna Concepts Radiation Patterns of Various Antennas Typical Installations Direct Connection Antenna Circuits Direct Connection Antenna Connection Antenna Circuits with Splitter Antenna Circuits with Splitter Antenna Circuits with Splitter and Lightning Suppressors Antenna Circuits with Splitter and Lightning Suppressors Plenum Cable Cross Reference Cable Assemblies AT-INT067265-00 - TNC Plug / N Receptacle, 12 inch...
Page 4
Introduction The purpose of this document is to provide Allied Telesyn, Inc. personnel a tool which will enable them to better understand how the various Allied Telesyn antennas, cable assemblies, and accessories blend together. Regulatory Concerns Note: The information below will help you to understand some of the regulatory issues surrounding the use of antenna, antenna circuits, and radios.
Page 5
Basic Antenna Concepts Antennas and Power Antennas do not increase nor decrease the power applied to them. They can only transmit or receive the amount of power that is applied to them. It is possible to have some power loss before or after the signal leaves the antenna.
Page 6
Radiation Patters of Various Antennas Omnidirectional: Circular patter in open spaces Range is slightly effected by antenna gain but the radiation pattern will remain relatively circular. Flat Panel: Modest directional coverage with a slight backlobe The main lobe of the radiation pattern can be from almost circular to fairly oblong in shape.
Page 7
WA7500 Direct Connection Antenna Circuit Any AlliedTelesyn 2.4 GHz, or 5.3 GHz (Mid-Band) Antenna with N Receptacle Connector WA7500 067266 - Cable - 2' (61cm) -- New Part #: AT-INT67266-00 2.4 GHz and 5.3 GHz (Mid-Band). 071178 - Cable - 12" (366cm) -- New Part #: AT-INT71178-00 *See Table on page 12 for plenum cable cross reference.
Page 10
Plenum Cable Cross Reference Description Plenum Cable Assembly Part Cable Assembly Number Length TNC Plug / N AT-INT072821-00 12 Inches Receptacle TNC Plug / N Plug AT-INT072822-00 24 Inches TNC Plug / N Plug AT-INT072823-00 12 Feet N Plug / N Plug AT-INT072824-00 30 Inches N Plug / N Plug...
Page 11
AT-INT067265-00 Cable Assy, TNC Plug / N Receptacle 12 Inch Used to connect AT-WA7500 to N Plug Cable Assys: AT-INT064616-00, AT-INT063245-00, AT-INT063246-00, AT-INT71179-00, AT-INT072824-00, AT-INT072825-00, AT-INT072826-00, and AT-INT072827-00. Cable loss standard (AT-INT067265-00): .2 DB at 2.4 GHz .3 DB at 5.35 GHz Cable loss plenum (AT-INT072821-00): .2 DB at 2.4 GHz...
Page 12
Cable Assy, TNC Plug / N Plug AT-INT67266-00 – 24 Inch standard AT-INT071178-00 – 12 Ft standard AT-INT072822-00 – 24 Inch plenum AT-INT072823-00 – 12 Ft plenum Connect AT-WA7500 to Antennas AT-INT63363-00, AT-INT063365-00, AT-INT63366-00, AT-INT065349-00, AT-INT067261-00, AT-INT67262-00, AT-INT67263-00, AT-INT71121-00, AT-INT71122-00, AT-INT072759-00, AT-INT072760-00, AT-INT072761-00, and AT-INT072762-00.
Page 13
Cable Assy, N Plug / N Plug AT-INT064616-00 – 30 Inch standard AT-INT063245-00 – 5 Ft standard AT-INT063246-00 – 20 Ft standard AT-INT71179-00 – 30 Ft standard AT-INT072824-00 – 30 Inch plenum AT-INT072825-00 – 5 Ft plenum AT-INT072826-00 – 20 Ft plenum AT-INT072827-00 –...
Page 14
AT-INT069886-00 Cable Assy, MMCX, Splice N Used to connect the AT-WL2411 radio with MMCX connector to Allied Telesyn N Plug Cable Assys, AT-INT064616-00, AT-INT063245-00, AT-INT063246-00, and AT-INT71179-00. ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 15
AT-INT069887-00 Cable Assy, Radiall, Splice N Used to connect the AT-WL2411 radio with Radiall (Lucent) connector to Allied Telesyn N Plug Cable Assys, AT-INT064616-00, AT-INT063245-00, AT-INT063246-00, and AT-INT71179-00. ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 16
AT-INT070402-00 Cable Assy, MMCX, N Plug Used to connect AT-WL2411 radio with MMCX connector to Allied Telesyn Antennas, AT-INT63363-00, AT-INT063365-00, AT-INT067261-00, AT-INT67262-00, AT-INT067263-00, AT-INT71121-00, and AT-INT71122-00. ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 17
AT-INT070403-00 Cable Assy, Radiall, N Plug Used to connect AT-WL2411 radio with Radiall (Lucent) connector to Allied Telesyn Antennas, AT-INT63363-00, AT-INT063365-00, AT-INT067261-00, AT-INT067262-00, AT-INT067263-00, AT-INT71121-00, and AT-INT71122-00. ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 18
AT-INT63363-00 Antenna, 2.4 GHz, Omni ETSI Size: 1.0 diameter x 11.5 inches 2.5 x 29.2 cm Hardware for mast installation provided. Approx. Beam Width Gain Azimuth Plane Elevation/Vertical Plane 5 DBI 360 degrees 30 degrees ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 19
AT-INT063365-00 Antenna, 2.4 GHz, Yagi Size: 26.0 x 4.0 x 1.0 inch 66.0 x 10.2 x 2.5 cm This antenna is designed to have the base attached to a wall. Hardware for mast installation is also provided. Approx. Beam Width Gain Azimuth Plane Elevation/Vertical...
Page 20
AT-INT63366-00 Antenna, 2.4 GHz, Flat Panel Size: 9.5 x 9.5 x 2.0 inch 24.1 x 24.1 x 5.1 cm Hardware for mast installation provided. Approx. Beam Width Gain Azimuth Plane Elevation/Vertical Plane 14 DBI 30 degrees 30 degrees ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 21
AT-INT065349-00 Antenna, 2.4 GHz, 9DBI, Omni ETSI Size: 1.7 diameters x 22.0 inches 4.3 x 55.9 cm Hardware for mast installation provided. Approx. Beam Width Gain Azimuth Plane Elevation/Vertical Plane 9 DBI 360 degrees 14 degrees ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 22
AT-INT066147-00 Antenna, TNC, 2.4 GHz, Dipole ETSI Size: .6 diameter x 6.0 inches 1.5 x 15.3 cm Approx. Beam Width Gain Azimuth Plane Elevation/Vertical Plane 1 DBI 360 degrees 90 degrees ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 23
Antenna, 2.4 GHz, 3DBI Mini Omni AT-INT067261-00 – with N Receptacle Connector AT-INT070140-00 – with MMCX Connector AT-INT070141-00 – with Radiall (Lucent) Connector Size: 2.0 x 2.5 x 1.0 inches ETSI 5.1 x 6.4 x 2.5 cm The back surface of this antenna can be mounted to a wall or a ceiling. Hardware for drop-ceiling installation is also provided.
Page 24
N Receptacle Connector used on the following Antennas: AT-INT63363-00, AT-INT063365-00, AT-INT067261-00, AT-INT067262-00, AT-INT067263-00, AT-INT71121-00, AT-INT71122-00, AT-INT072761-00, and AT-INT072762-00. Antennas AT-INT063366-00, AT-INT065349-00, AT-INT072759-00, and AT-INT072760-00 use the same style of N Receptacle but the connector is attached directly to the antenna. ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 27
AT-INT067262-00 Antenna, 2.4 GHz, 5DBI, Dual Flat Panel Size: 2.7 x 2.5 x .8 inches 6.9 x 6.4 x 2.0 cm This antenna should be installed so that the two larger surfaces each face down one direction of a corridor. Approx.
Page 28
AT-INT67263-00 Antenna, 2.4 GHz, 9DBI, Flat Panel Size: 5.0 x 5.0 x .75 inches 12.7 x 12.7 x 1.9 cm This antenna is mounted with the back surface to a wall. The side of the antenna where the cable exits is normally pointed to the ceiling. Also provided with Velcro patches, plastic drywall anchors self threading screws and Tilt Pan bracket.
Page 29
AT-INT067263-00 Antenna, 2.4 GHz, 9DBI, Flat Panel Rear View shown with Tilt Pan Mount ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 30
AT-INT71121-00 Antenna, 2.4 GHz, Diversity, 3DBI Size: 2.7 x 7.2 x 1.0 inches 6.9 x 18.3 x 2.5 cm Provided with integral clip for drop-ceiling installation. Gain 3 DBI ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 31
AT-INT71122-00 Antenna, 2.4 GHz, Corner Reflect Size: 6.0 x 5.5 x 3.0 inches 15.2 x 14.0 x 7.6 cm Hardware for mast installation provided. Approx. Beam Width Gain Azimuth Plane Elevation/Vertical Plane 9 DBI 65 degrees 75 degrees ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 32
Diversity Antenna, 2.4 GHz AT-INT071488-00 – with MMCX connector AT-INT71489-00 – with Radiall (Lucent) connector ETSI Size: 4.8 x 4.2 x 1.4 inch 12.2 x 10.7 x 3.6 cm Mounts to ceiling, wall, or desk. Hardware for drop-ceiling installation provided. Approx.
Page 34
AT-INT072759-00 Antenna, 5.25 – 5.35 GHz, Omni, 6 DBI FCC – Mid-Band Size: 1.24 diameter x 17.0 inches 3.2 x 43.2 cm Hardware for mast installation provided. Approx. Beam Width Gain Azimuth Plane Elevation/Vertical Plane 6 DBI 360 degrees 25 degrees ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 35
AT-INT072760-00 Antenna, 5.25 – 5.35 GHz, Omni, 9 DBI FCC – Mid-Band Size: 1.24 diameter x 19.75 inches 3.2 x 50.7 cm Hardware for mast installation provided. Approx. Beam Width Gain Azimuth Plane Elevation/Vertical Plane 9 DBI 360 degrees 14 degrees ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 36
AT-INT072761-00 Antenna, 5.25 – 5.35 GHz, Omni, 3 DBI, Ceiling Mount FCC – Mid-Band Size: 3.50 diameter x 1.4 8.9 x 3.6 cm Mounting kit includes screws and wall anchors. Gain Beam Pattern 3 DBI Hemispherical Omni-Directional ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 37
AT-INT072762-00 Antenna, 5.25 – 5.35 GHz, Corner Reflect FCC – Mid Band Size: 6.0 x 5.5 x 3.0 inches 15.2 x 14.0 x 7.6 cm Hardware for mast installation provided. Approx. Beam Width Gain Azimuth Plane Elevation/Vertical Plane 14 DBI 30 degrees 60 degrees ______________________________________________________________________________________...
Page 38
AT-INT069888-00 Kit, Bracket, Mounting, Antenna Used to mount Cable Assys, AT-INT069886-00, AT-INT069887-00, AT-INT070402-00, and AT-INT070403-00 to wall. Mounting screws provided. ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 39
AT-INT69893-00 Kit, Power Supply Holder, 5V Used to mount AT-WL2411 Power Supply to wall. Mounting screws provided. ______________________________________________________________________________________ PN 613-50537-00 Rev A...
Page 40
AT-INT061868-00 Lightning Suppressor Use between Cable Assys, AT-INT064616-00, AT-INT063245-00, AT-INT063246-00, or AT-INT71179-00. ______________________________________________________________________________________ PN 613-50537-00 Rev A...