Figure 13: Installing An Ac Plug On The At-Tq0091 Ac/Dc Power Adapter - Allied Telesis AT-AP500 Installation Manual

Draft 11-11-2016
6. Slide the correct AC plug for your region into the slot on the adapter
until it clicks into place. Refer to Figure 13.
Figure 13. Installing an AC Plug on the AT-TQ0091 AC/DC Power Adapter
7. Connect the AC plug on the power cord to an appropriate AC power
source. Refer to Table 7 on page 34 for the power specifications of the
power adapter.
After installing the access point on a wall or ceiling, go to "Kensington
Lock" on page 30 or "Starting the Initial Management Session on the
Access Point" on page 31.
AT-AP500 Wireless Access Point Installation Guide
29