Resetting Remote Communication And Reprogramming The Motor - SunSetter OASIS Owner's Manual & Assembly Instructions

Resetting Remote Communication and Reprogramming the Motor

• This procedure describes the actions needed to reset the communication between the Motor and the
primary Remote Transmitter used to control your Motorized Awning.
• This procedure programs the Awning Motor to accept commands from one primary Remote Transmitter.
• This procedure overwrites the factory set Open and Closed positions with new Open and Closed positions.
Note: To ONLY change the Open and Close preset positions, follow the basic procedure in Appendix A.
Tools needed: A pen or similar pointing device is needed to press and hold the Programming Button.
WARNING: ALL STEPS MUST BE FOLLOWED EXACTLY AND COMPLETELY.
PREPARE MOTOR - Read these instructions FIRST, completely and thoroughly.
Front View
1. Set the Remote Transmitter to Channel 1.
2. Press and Hold the my
3. Disconnect Power for two (2) full seconds.
4. Connect Power for ten (10) full seconds.
CLOSE
5. Disconnect Power for two (2) full seconds.
my
6. Connect Power. The Awning should move, then stop on its own.
7. Press and hold the Programming button for ten (10) seconds, watching for two (2)
OPEN
separate jogs back and forth, several seconds apart (about 6 seconds).
Note: A single jog is defined as a quick two-direction movement of the motor.
8. Press and Hold the CLOSE
Channel
Note: The Awning now moves ONLY while holding down the CLOSE
Indicator
SET PROPER DIRECTION OF MOTOR ROTATION
Lights
9. Press the OPEN
Channel
Selector
side should be rolling from the bottom of the Roller Bar (as you face the Gear Assembly or
Button
Motor), and the Fabric on the right side should be rolling over the top of the Roller bar.
10. If the direction is incorrect, change direction by holding the my
Rear View
Press the OPEN
SET THE CLOSED AND OPEN POSITIONS
11. Move the Awning to the desired Closed position.
12. Press and Hold the my
13. Press the my button to Stop the Awning at the desired Open setting.
14. Make desired adjustments to the Open position.
Programming
15. Press and Hold the my
Button is
begins to Close. Let the Awning stop on its own at the Closed position set in step 11.
inside small
opening.
16. Press and Hold the my
and Close positions.
Note: If steps 8 - 15 fail, unplug the Awning, plug it back in, then begin again from step 8.
FINALIZE PROGRAMMING OF MOTOR
17. Press and Hold the Programming button; wait for a jog. This completes the procedure.
Note: The Awning now operates with a touch and release of the OPEN
18. Test the Awning for correct one-touch operation, using the OPEN
To ADD an additional Control Device (such as a 2nd Remote, All Weather Remote or Wall Switch);
• Press the Programming button on the back of the Transmitter that was supplied with the Awning until
the motor "jogs."
• On the additional Control Device, press the Programming button until the Motor "jogs," then release
To DELETE a Control Device, repeat the two steps listed above and the additional Control Device is removed.
APPENDIX B
button; the red LED light should blink for at least 5 seconds.
and OPEN
button to check the direction of the motor rotation. The Fabric on the left
button again to check for the correct direction of the motor rotation.
and OPEN
and CLOSE
button; release when the Awning jogs. This step stores the new Open
To Add or Delete a Control Device (Transmitter)
buttons together, release when the Awning jogs.
buttons together; release when the Awning begins to Open.
buttons simultaneously; release them when the Awning
14
or OPEN button.
button until the motor jogs.
or CLOSE button.
and CLOSE
buttons.