Appendix B - Programming The Motor And Remote Transmitter - SunSetter EASYSHADE Owner's Manual & Installation Instructions

This procedure describes the actions needed to reset the communication between the Motor and the primary
Remote Transmitter used to control your Motorized EasyShade.
This procedure programs the EasyShade Motor to accept commands from one primary Remote Transmitter.
This procedure overwrites the factory set Up and Down positions with new Up and Down positions.
Note: To ONLY change the Up and Down preset positions, follow the basic procedure in Appendix A.
Tools needed: A pen or similar pointing device is needed to press and hold the Programming Button.
WARNING: ALL STEPS MUST BE FOLLOWED EXACTLY AND COMPLETELY
PREPARE MOTOR
Front View
1. Read these instructions FIRST, completely and thoroughly.
2. Press and Hold the my
3. Disconnect Power (at the Solar Panel connector) for 2 full seconds.
UP
4. Connect Power (at the Solar Panel connector) for 10 full seconds.
5. Disconnect (at the Solar Panel connector) Power for 2 full seconds.
my
6. Connect Power (at the Solar Panel connector). Your EasyShade should move then stop on its own.
7. Press and hold the Programming button for ten seconds, watching for two separate jogs back
DOWN
and forth, several seconds apart.
Note: A single jog is a quick two-direction movement of the motor.
8. Press and Hold the UP
Channel
Note: The EasyShade now moves ONLY while holding down the UP
Selector
SET PROPER DIRECTION OF MOTOR ROTATION
9. Press the DOWN
The Solar Screen should roll out of the Aluminum Housing, from the side closest to the house.
10. If the direction is incorrect, change direction by holding the my button until the motor jogs.
Rear View
Press the DOWN
SET THE UP AND DOWN POSITIONS
11. Move the EasyShade to the desired UP
12. Press and Hold the my
to move.
13. Press the my
14. Make desired adjustments to the Down position.
15. Press and Hold the my
begins to move Up. Let the EasyShade stop on its own at the UP
16. Press and Hold the my
Programming
Down position limits are set.
Note: If steps 8-15 fail, unplug the Power, plug back in, then begin again from step 8.
17. Press and Hold the Programming button, wait for jog. This exits the Programming Mode.
18. Process complete. Test the Up and Down stop position limits.
To ADD an additional Remote Transmitter for controlling this particular EasyShade.
• Press the Programming button on the back of the Remote Transmitter that was supplied with the
EasyShade until the motor "jogs."
• On the additional Remote Transmitter, press the Programming button until the motor "jogs," then release.
To DELETE a Control Device, repeat the two steps listed above; the additional Control Device is removed.
APPENDIX B
Programming the Motor
button; the red LED light will blink for at least 5 seconds, then release.
and DOWN
button to check the direction of the motor.
button again to check for the correct direction of the motor rotation.
and DOWN
button to Stop the EasyShade at the desired Down setting.
and UP
button, release when the Motor jogs. This step stores the Up and
Add/Delete a Control Device (Remote Transmitter)
buttons together until your EasyShade jogs.
position.
buttons together, release when the EasyShade begins
buttons together; release them when the EasyShade
14
or DOWN button.
position set in step 11.