SunSetter OASIS Owner's Manual & Assembly Instructions page 7

7. Repeat Steps 5 and 6 for the other end of the Awning Assembly.
MOTORIZED MODELS ONLY: remove the Nylon Cable Tie that is securing the Electrical Cord to the Awning
Top Bracket.
8. Locate the two (2) Square Bar Uprights packaged in the cardboard box. See Figure 5.
9. Orient one of the Square Bar Uprights so that the end of the Bar with the two holes that are approximately 3
inches apart is pointing toward the Awning Assembly. See Figure 5.
Figure 5
Bolt Holes 8" Apart
10. Push the Square Bar Upright onto the Awning Assembly Top Bracket,
making sure that the Bolt Holes in the Square Bar Upright, Corner Braces
and Awning Assembly (Top Bracket) are properly aligned. See Figure 5a.
11. Using two (2) sets of the hardware (nut, bolt and 2 washers) secure
the Corner Braces, Square Bar Upright and Awning Assembly (Top
Bracket) together. See Figure 5b.
12. Repeat Steps 10 and 11 for the other end of the Awning Assembly.
13. When the Square Bar Uprights have been installed, securely tighten
all eight (8) Bolts used to secure the Corner Braces.
14. Locate the two (2) Leg Assemblies packaged in the cardboard box
and the four (4) Black Plastic End Caps packaged with the Awning
Assembly. See Figure 6.
15. Install one (1) Black Plastic End Cap in each end of the Leg
Assemblies. Tap the Black Plastic End Caps securely in place with a
hammer. Attach two Rubber Pads underneath each Base Plate on each
Leg Assembly. See Figure 6.
Figure 6
Black Plastic
End Caps
Square Bar Upright
Base Plate
Leg Assembly
Base Plate
Horizontal Square Bar
Bolt Holes 3" Apart
Figure 5a
Figure 5b
Square Bar Upright
3
Corner
Braces Top Bracket
Top Bracket
Corner
Braces
Square Bar
Upright
Secured
with Nuts,
Bolts and
Washers.