SunSetter 900XT Homeowner’s Operation And Maintenance Manual
Hide thumbs
Also See for 900XT:
- Installation instructions (2 pages) ,
- Replacement (2 pages) ,
- Manual (2 pages)
Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for SunSetter 900XT
Summary of Contents for SunSetter 900XT
- Page 1 HOMEOWNER'S OPERATION MAINTENANCE MANUAL MODEL 900XT & 1000XT AWNINGS WARNING: Failure to follow these instructions could result in PERSONAL INJURY! www.sunsetter.com/ownerscorner For Technical support visit us at or call Toll Free 800-670-7071 • Fax 877-224-4944...
- Page 2 The following manual shows you how to properly operate your SunSetter awning. It is important that you follow the steps listed for the specific way that you plan to use your awning. NOTE: Left and right references are as you are Facing the house.
- Page 3 Both arms angled (Recommended for stronger wind support) OPEN: FIGURE 1 FIGURE 2 Using the hand crank, unroll the Extend both arms until the front roller awning until the front roller reaches reaches head height. waist height. OPEN Arrow Roller Bar Arrow Drive Unit FIGURE 3...
-
Page 4: Close
WARNING: DO NOT LEAVE THE AWNING UNATTENDED IN THIS POSITION. YOU MUST LOWER ONE ARM OR BOTH TO CREATE ENOUGH DROP (FRONT TO BACK) AND PREVENT RAIN FROM ACCUMULATING ON THE FABRIC. FAILURE TO DO SO MAY RESULT IN THE COLLAPSE OF THE STRUCTURE, WHICH COULD CAUSE PERSONAL INJURY. - Page 5 CAUTION: Once the awning is closed against the house, do not continue cranking. We recommend that the hand crank wand be removed from the crank loop when it is not in use to prevent damage to your house. FIGURE 5 Using the hand crank wand, roll up the awning until it is completely against the house.
- Page 6 FIGURE 5 FIGURE 6 Push both rafters 'UP' until they lock. Extend the LEFT arm until the front roller reaches head height. FIGURE 7 FIGURE 8 Unlatch the RIGHT arm from the wall Swing the arm to the fully vertical bracket.
- Page 7 FIGURE 11 Extend both arms to the desired height. WARNING: DO NOT LEAVE THE AWNING UNATTENDED IN THIS POSITION. YOU MUST LOWER ONE ARM OR BOTH TO CREATE ENOUGH DROP (FRONT TO BACK) AND PREVENT RAIN FROM ACCUMULATING ON THE FABRIC. FAILURE TO DO SO MAY RESULT IN THE COLLAPSE OF THE STRUCTURE, WHICH COULD CAUSE PERSONAL INJURY.
-
Page 8: Table Of Contents
CLOSE: UNLOCK Deck Plate FIGURE 1 FIGURE 2 Lower the LEFT arm until the front Release the RIGHT arm from the deck roller reaches head height. plate by lifting the ground bracket handle and rotating approximately 1/4 turn counter-clockwise to unlock. FIGURE 3 FIGURE 4 Extend this arm until the height of the... - Page 9 FIGURE 7 FIGURE 8 CAUTION: Be sure that both Rafters are Lower both arms all the way down. unlocked. Using the hand crank, roll up the awning until the front roller reaches head height. FIGURE 9 Using the hand crank, roll up the awning until it is completely against the house.
-
Page 10: Figure 3
OPEN Arrow Roller Bar Arrow Drive Unit FIGURE 3 FIGURE 4 Using the hand crank, unroll the Adjust the roller bar position until the awning until the fabric is fully arrow on the Roller Bar aligns with extended. the OPEN arrow on the side of the Drive Unit. -
Page 11: Deck Plate
Rotate Lift Deck Plate Deck Plate LOCK FIGURE 9 FIGURE 10 Place the bottom of the arm over the Release the handle and make sure it is deck plate that you installed. Secure locked in the 'down' position. Test the arm to the deck plate by lifting the to be sure that the arm is secured to ground bracket handle and rotating the deck plate. -
Page 12: House And Secure It To The Wall Bracket
CLOSE: UNLOCK Deck Plate FIGURE 1 FIGURE 2 Lower the RIGHT arm until the front Release the LEFT arm from the deck roller reaches head height. plate by lifting the ground bracket handle and rotating approximately 1/4 turn counter-clockwise to unlock. FIGURE 3 FIGURE 4 Extend this arm until the height of the... -
Page 13: Figure 7
FIGURE 7 FIGURE 8 CAUTION: Be sure that both Rafters Lower both arms all the way down. are unlocked. Using the hand crank, roll up the awning until the front roller reaches head height. FIGURE 9 Using the hand crank, roll up the awning until it is completely against the house. - Page 14 OPEN Arrow Roller Bar Arrow Drive Unit FIGURE 3 FIGURE 4 Using the hand crank, unroll the Adjust the roller bar position until the awning until the fabric is fully arrow on the Roller Bar aligns with extended. the OPEN arrow on the side of the Drive Unit.
-
Page 15: Handle And Rotating Approximately
Deck Plate LOCK FIGURE 9 FIGURE 10 Release the handle and make sure it is Extend both arms to the desired locked in the 'down' position. Test height. to be sure that the arms are secured to the deck plates. WARNING: DO NOT LEAVE THE AWNING UNATTENDED WITH BOTH ARMS VERTICAL. -
Page 16: Rafter Lock Latch
FIGURE 3 FIGURE 4 Using a helper swing both arms, at the Lower both arms until the front roller same time, back to the wall brackets. reaches waist height. Rafter lock Latch FIGURE 5 FIGURE 6 Unlock both rafters by pressing the CAUTION: Be sure that both Rafters are rafter lock latch. - Page 17 CARE AND MAINTENANCE OF YOUR SUNSETTER AWNING The awning fabric and the structure are not designed to support the load of water pooling on the fabric or excessive windy conditions. WARNING: YOU MUST PREVENT RAIN WATER FROM ACCUMULATING OR POOLING ON THE FABRIC! FAILURE...
- Page 18 CLEANING THE FABRIC Cleaning the awning regularly will extend the life of the fabric and prevent the formation of mildew. Call 1-800-876- 2340 to order a SunSetter cleaning and maintenance kit. Figure 12 FOR EASE OF OPERATION If it becomes difficult to raise and lower...
- Page 20 ©SunSetter Products, a Massachusetts Limited Partnership, 184 Charles Street, Malden MA 02148 Rev 10/13/03...