Resetting Remote Communication And Reprogramming The Motor; Add/Delete A Control Device (Remote, Remote Wall Switch, Wind Sensor) - SunSetter Platinum Plus Series Owner's Manual & Installation Instructions

Resetting Remote Communication and Reprogramming the Motor

This procedure will completely reset the communication between the Remote Transmitter and Motor, as well
as erase and reprogram the Open and Closed stop position settings of the Motor.
This procedure programs the Awning Motor to accept commands from one primary Remote Transmitter.
This procedure overwrites the factory set Open and Closed positions with new Open and Closed positions.
Note: To ONLY change the Open and Close preset positions, follow the procedure in Appendix A on Page 22.
Tools needed: A pen or similar pointing device is needed to press and hold the Programming Button.
WARNING: ALL STEPS MUST BE FOLLOWED EXACTLY AND COMPLETELY.
PREPARE MOTOR - Read these instructions FIRST, completely and thoroughly
Front View
1. Set the Remote Transmitter to Channel 1 (for single channel Remote, skip this step).
2. Press and Hold the my
3. Disconnect Power for two (2) full seconds.
CLOSE
4. Connect Power for ten (10) full seconds.
5. Disconnect Power for two (2) full seconds.
my
6. Connect Power. The Awning should move, then stop on its own.
7. Press and hold the Programming button for ten (10) seconds, watching for two (2)
OPEN
separate jogs back and forth, several seconds apart.
Note: A single jog is defined as a quick two-direction movement of the motor.
Indicator Lights
8. Press and Hold the CLOSE
Note: The Awning now moves ONLY while holding down the CLOSE
Channel
Selector
SET PROPER DIRECTION OF MOTOR ROTATION
Button.
9. Press the OPEN
Note: The fabric must roll from the top of the Roller Bar, when opening the Awning.
10. If the direction is incorrect, change direction by holding the my
Press the OPEN
SET THE CLOSED AND OPEN POSITIONS
Rear View
11. Move the Awning to the desired Closed position. Note: Fabric must roll over top of Roller Bar.
12. Press and Hold the my
13. Press the my button to Stop the Awning at the desired Open setting.
14. Make desired adjustments to the Open position.
15. Press and Hold the my
Programming
Button is
begins to Close. Let the Awning stop on its own at the Closed position set in step 11.
located
16. Press and Hold the my
inside
this small
and Close positions.
opening
Note: If steps 8 - 15 fail, unplug the Awning, plug it back in, then begin again from step 8.
FINALIZE PROGRAMMING OF MOTOR
17. Press and Hold the Programming button; wait for a jog. This completes the procedure.
Note: The Awning now operates with a touch and release of the OPEN
18. Test the Awning for correct one-touch operation, using the OPEN
To ADD an additional Control Device (such as another Remote or Channel, or a Wirless Wall Switch);
• Press the Programming button on the back of the Transmitter that was supplied with the Awning until
the motor "jogs."
• On the additional Control Device, press the Programming button until the motor "jogs," then release.
To DELETE a Control Device, repeat the two steps listed above and the additional Control Device is removed.
APPENDIX D
button; the red LED light should blink for at least 5 seconds.
and OPEN
button to check the direction of the motor.
button again to check for the correct direction of the motor rotation.
and OPEN
and CLOSE
button; release when the Awning jogs. This step stores the new Open
To Add or Delete a Control Device (Transmitter)
buttons together, release when the Awning jogs.
buttons together; release when the Awning begins to Open.
buttons simultaneously; release them when the Awning
26
or OPEN button.
button until the motor jogs.
or CLOSE
button.
and CLOSE buttons.