Assembly And Operating Instructions; Tools Required - SunSetter OASIS Owner's Manual & Assembly Instructions

Freestanding awning

Hide thumbs Also See for OASIS:

Replacement instructions manual (12 pages)

Replacement instructions (4 pages)

Replacement instructions manual (8 pages)

Table Of Contents

Table of Contents

WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN PERSONAL INJURY! PLEASE READ

THESE INSTRUCTIONS IN ITS ENTIRETY BEFORE ATTEMPTING TO COMPLETE THIS PROCESS.

WARNING: DO NOT REMOVE THE PLASTIC SAFETY SLEEVES FROM THE LATERAL ARMS UNTIL INSTRUCTED TO

DO SO.

CAUTION: Do not remove the Red Foam Packing located at the middle of the Oasis Awning Assembly until

instructed to do so.

1. Before beginning, please familiarize yourself with the components of the Oasis Awning as shown in Figure 1,

and the supplied Parts shown on Page iv.

Note: The Oasis Awning should be assembled in the general area that it will be used. The area of use should

be flat and level. It should have unobstructed overhead clearance to a height of approximately 9 feet.

Tools Required:

You will need a Helper, 9/16" Socket and Driver, Mallet (or Hammer), 9/16" Wrench, Step Ladder, 2 or 3 Chairs or

Saw Horses (position Oasis on these during assembly process).

Note: Two additional Helpers will be needed to place the assembled Awning in the upright position.

A video outlining the Oasis assembly process is available at http://ownerscorner.sunsetter.com.

Figure 1

Motor or Drive Gear

Lateral Arm

Base Plate

Left Side

SunSetter Oasis Freestanding Awning