Protective Cover; Installation Instructions; How To Safely Remove Bungee Cords From The Cover - SunSetter OASIS Owner's Manual & Assembly Instructions

Protective Cover - OASIS Freestanding Awning
Tools Needed: Step Ladder (2)
Parts Supplied: Cover, Bungee Cords (7 for 12ft model, 9 for 16ft model)
WARNING: FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN PERSONAL INJURY.
Make sure that your Oasis Awning is in the fully closed position.
Remove the Protective Cover from its packaging. Orient the Cover so that the sewn hem is facing down.
With your helper carefully place the Cover (hem facing down) on top of the Oasis Awning assembly and extend
the Cover the length of the Oasis Awning. The Cover is designed to extend approximately 2 inches beyond
each end of the Oasis Awning. See Figure 1.
Locate the Bungee Cords and insert one of the Bungee Cords through the Grommet at each side of the Cover
(see Figure 2) and secure the Loop over the Ball. See Figure 3.
Figure 1
Oasis
Cover
WARNING: IF YOUR COVER IS SECURED TO THE OASIS AWNING WITH
BUNGEE CORDS OR ANY OTHER TIE DOWNS, FAILURE TO FOLLOW THESE
INSTRUCTIONS WHEN REMOVING THE BUNGEE CORDS FROM THE COVER
COULD RESULT IN PERSONAL INJURY.
WARNING: DO NOT PLACE THE LADDER OR STAND IN FRONT OF THE OASIS
AWNING FRONT BARS. DOING SO COULD RESULT IN PERSONAL INJURY.
To make sure that the Oasis Awning is completely closed under the Protective
Cover, inspect the following conditions from the end of the Oasis:
1. Check to make sure that the Fabric between the Front Bars and the
Roller Bar is tight. See Figure 1.
2. If the Fabric is loose or sagging (see Figure 2), push the CLOSE button
on your Remote Transmitter or use the manual hand Crank Wand to
fully close the Oasis Awning and wrap the Fabric tightly around the
Roller Bar.
3. Check to make sure that the Fabric is now tight between the Front Bars
and Roller Bar. See Figure 1.
4. Position yourself under the Oasis Awning. Remove the Bungee Cords
one at a time.
5. Test the operation of your Oasis Awning using the OPEN and CLOSE
buttons on the Remote Transmitter.
Installation Instructions - 'Helper Needed'
Figure 2
Bungee
Cord
Ball
How to Safely Remove the Bungee Cords from the Cover
Bungee
Cord
Loop
Horizontal Square Bar
10
Figure 3
Horizontal
Square Bar
Bungee Cord Loop Secured
Over Bungee Cord Ball
Figure 1
Fabric Tight
Fabric Shown Tight
on Roller Bar
Front Bars
Figure 2
Fabric Loose / Sagging
Fabric Shown
Loose on
Roller Bar
Front Bars