Siemens SINAMICS G120 CU240B-2 Operating Instructions Manual page 85

Changing parameter values using the expert list
● If you wish to specifically change parameters, then - as shown below - call the expert list;
Saving settings so that they are not lost when the power fails
All of the changes that you make are temporarily saved in the inverter and are lost the next
time the power supply is switched off. For your changes to be permanently saved in the
inverter, you must save the changes using the
the button, you need to mark the appropriate drive in the project navigator.
Go offline
You can now exit the online connection after the data backup (RAM to ROM) with
"Disconnect from target system".
Inverter with CU240B-2 and CU240E-2 Control Units
Operating Instructions, 07/2010, FW 4.3.2, A5E02299792B AA
there, scroll to the parameter and then change its value. You close the expert list by
double clicking on an entry in the STARTER project tree.
4.5 Commissioning with STARTER
button (RAM to ROM). Before you press
Commissioning
85