Procedure
3.4 Laminating and finishing
14
Turn on the vacuum and check the PVA bag to make
sure there are no leaks.
Mix the lamination resin with the hardener.
NOTICE: To avoid overheating during curing, no
more than 1.5% hardener should be added.
Carry out the lamination process.
After the laminate has fully hardened, mark the course
of the edge on the orthosis.
Use a knife to expose the lamination dummy cover and
the insertion zone of the lamination bar.
Remove the Pastasil from the screws.
Unscrew the screws from the lamination dummy and
lamination bar.
17AD100