Otto Bock 17AD100 Nexgear Tango Technical Information page 6

Procedure
3.3 Reinforcing
Bar and clamp
6
Glue the profile material to the lamination bar. Firmly
press the gluing surfaces together.
INFORMATION: Before reinforcing, roughen the
bar and foot stirrup and clean them using a
degreasing cleaner.
Reinforce the foot stirrup with carbon fibre stockinette,
letting the woven stockinette project approx. 5 cm bey­
ond the foot stirrup.
Depending on the orthosis construction and the patient-
specific requirements, pull 1 to 3 layers of woven stock­
inette over the foot stirrup.
Wrap the reinforcement with an unwaxed thread over
the length of the foot stirrup to form fit the carbon
fibres. Do not wrap the projecting woven stockinette.
Reinforce the lamination bar and PVC profile material
with woven stockinette and wrap with unwaxed thread.
17AD100