Otto Bock 17AD100 Nexgear Tango Technical Information page 16

Procedure
3.5 Mounting the orthosis joint
16
The shape of the lamination dummy produces the
desired contour to enable the full range of motion of the
orthosis joint without damaging the laminate.
Check the fit of the bearing bushing in the foot stirrup,
or install the bearing bushing if it is missing.
INFORMATION: Mounting the lower leg component
is not necessary to install the orthosis joint and
individual modules.
Mount the orthosis joint with suitable axial washers:
• Position two axial washers of the same thickness
medially and laterally on the foot stirrup and slide on
the orthosis joint.
• Use thicker axial washers in case of play in the
medial-lateral direction.
17AD100