Otto Bock 17AD100 Nexgear Tango Technical Information page 4

Procedure
4
Insert the foot stirrup into the lamination dummy cover,
leaving the bearing bushing in the foot stirrup.
Slide the lamination dummy cover with the shoulder
screw onto the lower part of the lamination dummy and
mark the insertion zone on the bar and foot stirrup.
Remove the bar and foot stirrup from the lamination
dummy for machining.
NOTE: Do not machine the insertion zone of the
bar and foot stirrup.
INFORMATION: The foot stirrup is secured in the
neutral position by the design of the lamination
dummy cover.
The neutral alignment of the foot stirrup permits
the maximum dorsal or plantar range of motion in
the orthosis joint.
Mould the foot stirrup and shorten it to the height of the
outside edge of the foot.
Screw the lamination dummy, lamination bar and foot
stirrup to the alignment insert with the shoulder screw.
17AD100