Brainlab VECTORVISION Series Technical User Manual page 41

VECTORVISION² NAVIGATION STATION
LED Status
Indicators: Non-
Standard
On/
Conditions
Standby
LED
Green
Green
Blinking
y e l l o w /
green
Blinking
green
Off
Green
Off
Off
NOTE: See troubleshooting section on page 77.
Technical User Guide Rev. 2.7 VectorVision & Kolibri
Bat
Bat Service
Low
LED LED
LED
On Off Off
On On Off
Off Off Off
Off Off Off
Blinking
Off Off c o n -
stantly
Blinking
Off Off c o n -
stantly
Flashing
Off Off every 4
sec.
Blinking
Off Off c o n -
stantly
Beeper System Status
System is on and running on battery
8 sec.
(mains power failure)
Battery is low and system must be
connected to mains power for at least
C o n - four hours.
stant The system may crash due to low bat-
tery if mains power is not immediately
reconnected.
Button panel is waiting for PC to shut
down.
Off
A shut-down is forced at latest, after
two minutes.
Button panel tried to turn on the PC,
Off but the PC did not start.
Check cabling and workstation.
Internal cabling fault or temperature
8 sec.
warning
Off System is in service mode
Service request. 500 hours run-time
Off completed.
Counter must be reset.
An extreme temperature was mea-
sured and system was shut down by
the button board.
C o n -
Unplug system and investigate cause
stant
of high temperature.
Do not reconnect system without
checking for potential fire hazards.
41