Install The Router Using A Router Transport Kit; Unpack The Router Transport Kit - Juniper MX2020 Quick Start Manual

MX2020 3D Universal Edge Router Quick Start

Install the Router Using a Router Transport Kit

28
Insert sixteen mounting screws (eight on each side) into the mounting holes to secure
13.
the router to the rack.
Visually inspect the alignment of the router. If the router is installed properly in the
14.
rack, all the mounting screws on one side of the rack should be aligned with the
mounting screws on the opposite side, and the router should be level.
Unpack the Router Transport Kit on page 28
Install the Router Transport Kit onto the Router on page 30
Use the Transport Kit to Install the Router in the Rack on page 32

Unpack the Router Transport Kit

The router transport kit is shipped in a wooden crate. A wooden pallet forms the base of
the crate. Metal clips secure the top and front of the crate in place.
The router transport kit shipping container measures 36 in. (91.4 cm) high, 32 in. (81.3 cm)
wide, and 44.5 in. (113 cm) deep (see
container containing the router transport kit is 200 lb (90.71 kg).
Figure 17: Router Transport Kit Crate Dimensions
Crate door/ramp
3 ft
(91.44 cm)
3 ft
(91.44 cm)
3 ft
(91.44 cm)
NOTE: The router transport kit is maximally protected inside the shipping
crate. Do not unpack it until you are ready to begin installation.
To unpack the router transport kit:
Move the router transport kit shipping crate to an ESD-approved staging area, where
1.
you have enough room to remove the kit for assembly.
Position the shipping crate with the arrows pointing up.
2.
Figure 17 on page 28). The total weight of the
44.5 in
(113 cm)
Copyright © 2015, Juniper Networks, Inc.
32 in
(81.3 cm)
36 in.
(91.4 cm)
3 ft
(91.44 cm)