Step 4: Connect The Grounding Cable - Juniper MX2020 Quick Start Manual

Step 4: Connect the Grounding Cable

Copyright © 2015, Juniper Networks, Inc.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to an approved site ESD grounding point. See the instructions for your site.
Connect the grounding cable to a proper earth ground.
2.
Verify that a licensed electrician has attached the cable lug provided with the router
3.
to the grounding cable.
Make sure that grounding surfaces are clean and brought to a bright finish before you
4.
make grounding connections.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
5.
the strap to one of the ESD points on the chassis. For more information about ESD,
see the MX2020 3D Universal Edge Router Hardware Guide.
Place the grounding cable lug over the grounding points. The upper pair is sized for
6.
UNC 1/4-20 bolts, and the lower pair is sized for M6 bolts.
Secure the grounding cable lug to the grounding points, first with the washers, and
7.
then with the nuts (see
Figure 30: Grounding Points on the MX2020 Router
Verify that the grounding cabling is correct, that the grounding cable does not touch
8.
or block access to router components, and that it does not drape where people could
trip on it.
Figure 30 on page 43).
Step 4: Connect the Grounding Cable
43