GREE ELECTRIC GUHD09NK3CO Service Manual page 183

Remove panel parts
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during disassembly. Do not scratch the
outer parts.
Step
Remove panel
parts
Remove sub-assy of electric box
Remark: Make sure that the power supply is cut off before disassembling and protect all the parts during disassembly, especially the
components inside the box in case of water and hit.
Step
1. Remove
electric box
cover
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during disassembly, especially the joints
Step
R e m o v e s u b -
a s s y o f a i r
Remove water-containing plate modules
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during disassembly.
Step
R e m o v e w a t e r-
containing plate
modules
Illustration
Illustration
Illustration
Illustration
U-Match Series DC
Inverter Service Manual
Handling Instruction
in the graph with screwdriver (two on
both right and left and 4 in the front) and
then remove the panel parts.
Handling Instruction
arrow in the graph on left and remove
the electric box cover.
Handling Instruction
from the air deflecting plate support
assembly, and then remove both ends
from the air sweeping motor joint.
(As is shown in the graph, arrow
represents the support assembly and
circle the air sweeping motor joint.)
Handling Instruction
plate modules.
180