GREE ELECTRIC GUHD09NK3CO Service Manual page 167

7 . R e m o v e t h e
compressor .
8 . I n s t a l l a n e w
compressor on the
compressor support.
9. Connect the pipes
of the compressor to
the system .
10. Install a gas-
liquid separator and
U-Match Series DC
Inverter Service Manual
R e m o v e t h e c o m p r e s s o r f r o m t h e
compressor support.
A. Put a new compressor in the right
place.
C. The compressor should not be up-side
down.
A. Weld the pipes of the compressor.
B.During soldering, charge nitrogen
with pressure of 0.5±0.1kgf/cm
pressure)
C.Do not burn the surrounding material
during heating.
A. Put the gas-liquid separator in the
right place.
B. Tighten the screws fixing the gas-
liquid separator and the isolation sheet.
2
(relative
164