GREE ELECTRIC GUHD09NK3CO Service Manual page 145

6. Remove the back
panel.
7.Disassemble the
right side panel.
8. Remove the right
side panel.
Removal and Installation of Gas-liquid Separator and Compressor
Remark: Before removing the compressor, make sure that there is no refrigerant inside the pipe system and that the power has
been cut off.
Step
1 . D i s c o n n e c t
the wiring of the
power supply of
the compressor
2 . L o o s e n t h e
s c r e w s o n t h e
compressor
Illustration
U-Match Series DC
Inverter Service Manual
Remove the back panel
away from the unit .
Loosen the screws on the
side panel with a screw
drive.
Remove the right side
panel away from the unit.
Handling Instruction
a. Open the cover of the power supply
box with a wrench.
b. Disconnect the power cord of the
compressor with the pliers.
c. Pull out the power supply plug of the
compressor.
L o o s e n t h e s c r e w s b e t w e e n t h e
compressor and the compressor base
with a wrench.
142