Texas Instruments ADS1278EVM-CVAL User Manual page 12

Using the ADS1278EVM-CVAL Plug-in ADCPro
4 Using the ADS1278EVM-CVAL Plug-in ADCPro
The ADS1278EVM-CVAL plug-in for ADCPro provides complete control over all settings of the ADS1278-
SP. It consists of a tabbed interface (see
tabs are:
• Channel Enable
• Settings
• About
The user can adjust the ADS1278EVM-CVAL settings when not acquiring data. During acquisition, all
controls are disabled and settings may not be changed. When a setting is changed on the ADS1278EVM-
CVAL plug-in, the setting immediately updates on the board.
Settings on the ADS1278EVM-CVAL correspond to settings described in the
sheet product data sheet.
4.1 Top Level Controls
You can adjust the ADS1278EVM-CVAL settings when you are not acquiring data. During acquisition, all
controls are disabled and settings may not be changed.
The effective data rate of the ADS1278-SP depends upon settings of the Clock Freq and Operating Mode.
The Data Rate indicator in the upper right corner of the plug-in interface (see
and updates whenever a setting changes that affects the data rate.
4.2 Channel Enable Tab
The ADS1278-SP can acquire data from one to eight channels simultaneously. The Channel Enable tab
(as shown in Figure
12
ADS1278EVM-CVAL Evaluation Module User's Guide
Figure
10) provides the control to power on or off each channel.
Copyright © 2018, Texas Instruments Incorporated
10) with different functions available on different tabs. The
www.ti.com
ADS1278-SP product data
Figure 10) is always visible
SBAU324 – September 2018
Submit Documentation Feedback