Table of Contents
Advertisement
ATOM DX system installation overview
This section gives an overview of the steps involved in installing, setting-up and calibrating an ATOM DX encoder system. More detailed information is contained within the rest of the document.
For information on designing the readhead and scale into the system refer to the detailed 3D models at
IMPORTANT: Prior to installing readhead and scale, installation drawings should be reviewed to ensure correct orientation of readhead relative to scale.
RTLF (tape scale)
Ledge or dowel mount
Scale applicator
< 500 mm only
Any length
(page 8)
(page 10)
Fit datum clamp
(page 12)
Fit end covers
(page 12)
Deselect unused reference marks
(page 13)
ATOM DX
linear installation guide
Scale mounting
RKLF (narrow tape scale)
RCLC (glass spar)
Ledge or
Scale applicator
dowel mount
(page 10)
(page 15)
Fit end clamps
Apply epoxy datum
(page 13)
(page 16)
System connection
www.renishaw.com/atomdxdownloads
or contact your local Renishaw representative.
Fixed mounting
Shim kit
(page 19)
System connection
Mount and align readhead
Adjustable bracket
Dummy head
(page 20)
Calibrate system
(page 23)
Accurate bracket
(page 21)
4
Advertisement
Table of Contents
