Computer Instructions - Energetics CT- 750 Assembly Instruction Manual

Computer Instructions

DISPLAY
SET key to enter
training data
RECOVERY key to
activate recovery
function
Operating Instructions Computer CT- 750
BATTERIES. Open the battery compartment at the rear of the computer and install 2 x AA batteries. If the LCD is not clear
and only partial segments are displayed then remove the batteries, wait 15 seconds, and reinstall them. If the problem
persists then install new batteries. If new batteries do not fix the problem then consult your retailer. Under normal use the
batteries will last one year.
POWER ON. The power will automatically turn on when the batteries are installed or the MODE key is pressed or the
computer receives a speed signal.
COMPUTER FUNCTIONS
AUTO POWER OFF/ON. As long as you are working out the computer will operate. If there is not input for 4 minutes then
the computer will automatically turn off. All existing values will be held until the computer is powered up again.
START STOP. If no sensor input is detected for 4 seconds the computer will stop and STOP will be displayed. All
functions will resume when the sensor input in reactivated.
SCAN. When selected this will automatically scan all functions sequentially and display each for 6 seconds. To select
SCAN press the MODE key until SCAN appears.
ELAPSED TIME. TIME counts up from 00:00 to 99:59. To display TIME only press the Mode key until TMR appears.
To preset time to countdown press the MODE KEY until TMR appears on the display. Press the SET key and the
displayed value will cycle up. By pressing and holding the SET key for 2 seconds the display will self-cycle quickly. To stop
the self-cycling mode press the SET key again. TIME is preset when the desired value is displayed. To reset TIME to zero
press the RESET key.
SPEED. SPEED is displayed in km/h from 0.0 to 99.9. To display SPEED only press the Mode key until SPD appears.
DISTANCE. DISTANCE is displayed in km/h from 0.00 to 99.99. To display DISTANCE only press the Mode key until DST
appears. To preset DISTANCE to countdown press the MODE KEY until DST appears on the display. Press the SET key
and the displayed value will cycle up. By pressing and holding the SET key for 2 seconds the display will self-cycle quickly.
To stop the self-cycling mode press the SET key again. DISTANCE is preset when the desired value is displayed. To reset
DISTANCE to zero press the RESET key. NOTE. DISTANCE can be preset in 0.1km steps only.
CALORIES. CALORIES is displayed in Kilocalories from 0 to 9999. To display CALORIES only press the Mode key until
CAL appears.
17
- -
RESET key to clear
training data
MODE key to
select displayed
function