44
model no. 055-6755-8 | contact us 1-800-689-9928
•
Raise the blade to the maximum height by turning the
height-adjusting knob clockwise.
•
Using a framing square (1), set the blade to exactly
90°.
•
If the blade stops bevelling before it gets to 90°,
loosen the 90°-stop set screw (2) (located at the left
of the bevel track on the front) with 4 mm hex key
(not supplied), and then adjust it to 90°.
•
With the blade (3) set at 90°, slowly turn the 90°-stop
set screw (2) until you feel resistance. Bevel the blade
away from 90° a little, and then back to the stop.
•
Re-measure the angle and repeat the stop adjustment
as necessary, until the blade stops at 90°.
•
Set the 45° stop in the same way. The 45°-stop set
screw (4) is located at the right of the bevel track on
the front. Use the triangle square (5).
•
Replace the anti-kickback pawls assembly and blade
guard assembly.
•
Make a test cut.
ADJUST THE BEVEL INDICATOR (Fig. 21)
•
If the bevel indicator (1) is not at 0° when the saw
blade is at 90°, adjust the indicator (1) by loosening
the cross screw (2) with a star-head screwdriver and
setting it to 0° on the bevel scale.
•
Retighten the cross screw (2).
•
Make sure that you make a trial cut on a scrap piece
of wood before making critical cuts. Measure for
exactness.
NOTE:
Make sure that the square contacts the flat part of the saw blade, not the blade teeth.
2
4
Fig. 20b
3
5
Fig. 20c
1
2
Fig. 21
INSTALL BLADE GUARD STORAGE (Fig. 22)
•
Align the holes in the blade guard storage (1 & 2) with
corresponding holes on the rear of the saw.
•
Insert screws ST 4.2 x 12 (3) the into the aligned
holes of the blade guard storage and the rear of the
saw.
•
Tighten the screws (3) with a star-head screwdriver.
INSTALL ANTI-KICKBACK PAWLS STORAGE
(Fig. 23)
•
Align the holes in the anti-kickback pawls storage (1)
with corresponding holes on the rear side of the saw.
•
Insert screws ST 4.2 x 12 (2) the into the aligned
holes of the anti-kickback pawls storage and the rear
side of the saw.
•
Tighten the screws (2) with a star-head screwdriver.
INSTALL RIP FENCE STORAGE (Fig. 24)
•
Align the holes in the rip fence storage (1 & 2) with
corresponding holes on the right side of the saw.
•
Insert screws ST 4.2 x 12 (3) the into the aligned
holes of the rip fence storage and the right side of the
saw.
•
Tighten the screws (3) with a star-head screwdriver.
INSTALL PUSH STICK STORAGE SCREWS
(Fig. 25)
•
Insert the push stick storage screws (1) into holes on
the right side of the right extension table.
•
Use the screwdriver to tighten the screws (1) securely.
45
3
1
2
3
Fig. 22
1
2
Fig. 23
2
1
3
Fig. 24
1
Fig. 25